
Strix upgrade instructions			2024-08-27 


1 Turn on your Sentrac with the Strix probe to upgrade connected, and wait until the operation screen is shown. (Alternatively press 3 times in the O of INFICON)

2 Copy the files (strix.inf + strix_vx_xx_xx.img) to the USB-C memory stick.
  If these files already has been copied to the Sentrac, Sentrac will, after warmup, check if the Strix probe connected has an older s/w version and
  ask if it shall be upgraded. Then skip this step end go directly to step 5.   

3 Attach the USB memory stick to Sentrac. 
  A pop-up screen is shown indicating that an probe upgrade was found on the USB. (If the version is already exist on Sentrac, no pop-up screen will appear)

4 Press the accept button to start the upgrade process.
  The upgrade files are now copied to internal memory in Sentrac. This will take 10-12 seconds.  

5 A pop-up screen will then appear asking you to start the probe upgrade. Press accept.
  First, the data is sent to the Strix probe. The transfer process is shown on the Sentrac screen and on the Strix screen.

6 After fulfilled transfer the probe screen will be green for about 30 seconds. Now the data is decrypted and the old software is replaced.

7 The installation is ready when the Strix screen shows the splash screen again.

8 Don't forget to remove the USB memory stick

